Publicité
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
Warning!
This equipment generates an
electromagnetic fi eld during operation. Under
certain circumstances this fi eld may actively
or passively impede medical implants. To
reduce the risk of serious or fatal injuries, we
recommend persons with medical implants
to consult their doctor and the manufacturer
of the medical implant prior to using the
equipment.
5. Before starting the equipment
The lawn mower is delivered partly assembled.
The push bar and the collection bag must be
assembled before using the lawn mower. Follow
the instructions step by step and refer to the
pictures when assembling.
Fitting the push bar
Fit the top push bar (2) and the push bar holder
(3) as shown in Fig. 3-6.
The push bar can be adjusted to 3 diff erent
settings.
Warning!
Always set the identical handle height on both
sides.
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 14
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 14
EN
Fitting the collection bag (Fig. 7)
Before you fi t the collection bag you must ensure
that the motor is switched off and the blade is
not rotating. Also pull out the safety plug (16) and
remove all the batteries (25). Lift the ejector fl ap
(7) with one hand. With the other hand, hold the
collection bag by the handle and hook it in from
above.
Filling level indicator of the collection bag
(Fig. 2,16)
The collection bag is equipped with a fi lling level
indicator (19), which is lifted by the airfl ow that
the lawn mower generates during operation. If this
drops down during mowing, this means that the
collection bag is full and needs emptying.
Adjusting the cutting height
Caution!
Adjust the cutting height only when the machine
has been switched off , the safety plug (16) has
been pulled out and the batteries (25) removed.
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners
are damaged. To prevent any imbalance, replace
blunt and/or damaged blades. To carry out this
check, fi rst switch off the motor and pull out the
safety plug.
The cutting height is adjusted as follows
(Fig. 12):
1. Push the lever (6) outwards.
2. Set the lever (6) to the desired cutting height.
3. Release the lever (6) and check that it is
securely seated in the lock.
Using the mulching adapter (Fig. 8)
In mulching mode the cuttings are shredded in
the enclosed mower housing and then spread
back onto the lawn. It is not necessary to gather
and dispose of the grass.
Important! Mulching is only possible if the
lawn is relatively short.
Warning!
Insert the mulching blade only when the machine
has been switched off , the safety plug (16) has
been pulled out and the batteries (25) removed.
To use the mulching function, disconnect the
collection bag, slide the mulching adaptor (20)
through the ejector opening and close the ejector
fl ap again.
- 14 -
23.07.2024 08:59:52
23.07.2024 08:59:52
Publicité
