Publicité
Handling
a) Only mow in broad daylight or in well-lit
conditions.
b) Do not use the machine on wet grass.
c) Always maintain good footing on inclines.
d) Only operate the machine at a walking pace.
e) Always mow across slopes, i.e. never straight
up or straight down.
f)
Be particularly careful when you change
direction on a slope.
g) Do not mow on overly steep inclines.
h) Always be extra careful when turning the
mower around and when pulling it towards
you.
i)
Switch the mower off , pull the safety plug and
wait until the blade has reached a complete
standstill if you need to tip the mower over,
transport it over surfaces other than grass
and if the mower has to be moved from and to
the area you wish to mow.
j)
Never use the lawn mower if the guards are
damaged or without the attached guards, e.g.
defl ectors and/or grass catching devices.
k) Use the On/Off switch carefully as described
in the manufacturer's instructions. Make sure
that your feet are far enough away from the
mower blade!
l)
The lawn mower should not be tilted when the
motor is switch on unless it has to be raised
for starting purposes. In this case, tilt it as little
as absolutely necessary and only raise the
side opposite to that of the user.
m) Do not switch on the mower if you are
positioned in front of the chute.
n) Never move your hands or feet toward or
under any rotating parts. Keep clear of the
chute opening at all times.
o) Never lift or carry a lawn mower with the
engine running.
p) Switch off the motor and pull out the safety
plug. Make sure that all moving parts have
reached a complete standstill.
- Before you dislodge any blockages or clogs
in the chute.
- Before you carry out any checks, cleaning,
maintenance or other work on the lawn
mower.
- If you have struck a foreign object.
Examine the mower for signs of damage
and carry out any necessary repairs before
restarting and continuing to work with the
mower.
- If the lawn mower begins to experience
exceptionally strong vibrations, immediately
switch it off and check it.
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 12
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 12
EN
q) Switch the mower off , pull the safety plug and
make sure that all moving parts have reached
a complete standstill.
Maintenance and storage
a) Make sure that all nuts, bolts and screws are
tightened securely and that the machine is in
safe working condition.
b) Allow the mower to cool before you put it into
an enclosed area.
c) To avoid the risk of fi re, keep the motor
housing and ventilation slots clear of grass,
leaves, oil and grease.
d) Routinely check the collection bag for signs of
wear and impaired functionality.
e) For your own safety, have worn or damaged
parts replaced without delay.
f)
Take care not to jam your fi ngers between
moving blades and stationary parts of the
equipment while you are adjusting the
equipment.
g) While you are carrying out maintenance work
on the blades, remember that the blades can
still be moved even if the power source has
been switched off .
SAVE THESE INSTRUCTIONS
2. Layout and items supplied
2.1 Layout
1. Switching bar
2. Upper push bar
3. Push bar holder
4. Battery covering hood
5. Collection bag
6. Lever for cutting height adjustment
7. Ejector fl ap
8. Safety lock-off
9. Steel mowing deck
10. Short screw (2x)
11. Handle screw (2x)
12. Long screw (2x)
13. Clamping lever (2x)
14. Adapter (2x)
15. Washer (2x)
16. Safety plug
17. Cable clip (2x)
18. Wheel cap
19. Filling level indicator
20. Mulching adapter
21. Side ejector adapter
22. Drive lever (clutch lever)
23. Speed adjuster lever
- 12 -
23.07.2024 08:59:52
23.07.2024 08:59:52
Publicité
