Publicité
3. Mount the upper cover onto the middle cover, ensuring the pin of the former is locked inside the
catch of the latter (fig. 3).
4. Secure the upper cover and the middle cover using the locking pad (fig. 4).
5. Loosen the handwheel and lift the handle up and down to ensure the appliance is assembled securely
(fig. 5).
3
4
6. Place the vegetables in the feeding chute. Then lower the pusher handle fully.
7. Place a container beneath the cutter mouth to collect the cut vegetables. The appliance is now ready
for use.
Changing the cutting disc (for DN630)
Warning: The blades on the cutting disc are sharp. Handle with care!
1. Turn off and disconnect the appliance from the mains power supply.
2. Release the locking pad and remove the upper cover.
3. Turn the locking nut anti-clockwise to remove first. Turn the cutting disc anti-clockwise and remove.
This may require a sharp tap to free it from the shaft.
4. Slot the new disc in place. Turn if necessary to drop the disc in place. Mount the locking nut in place.
Note: Ensure the appliance is clean and free from food debris when changing disc to ensure
the disc can be securely fitted.
5. Locate the upper cover and pusher handle consecutively in place.
Tip: When in use, press down on the pusher handle or the food pusher. As the vegetables
are cut, they will be ejected from the cutter mouth.
Caution: NEVER use the pusher for the big feeding chute, as this may lead to appliance
damage or personal injury.
DM070 (+DN630)_ML_A5_v2_20241113.indb 7
DM070 (+DN630)_ML_A5_v2_20241113.indb 7
EN
5
7
2024/11/13 10:12
2024/11/13 10:12
Publicité
