EN
Operation
1. Connect the appliance to the mains power supply.
2. Press the Start button (I) to turn on.
3. Pulse function: Press down and hold the pulse button (T) to start. Release to stop.
4. Once all food are cut, press the Stop button (O) to turn Off. Disconnect from power supply and let
the motor cool down.
Cleaning, Care & Maintenance
Always turn off and disconnect the appliance from the power supply before cleaning.
•
•
Allow to cool before cleaning.
•
Let the motor come to a complete stop before disassembly and cleaning.
•
Remove all food debris.
•
Never immerse the motor base in water, nor rinse it under running water. Clean the surface using a
damp cloth.
•
Use warm, soapy water and a damp cloth to clean all removable parts.
•
Dry all parts well and re-assemble.
•
Periodically lubricate the shaft with some vegetable oil.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not
working
Unit does not work
after assembled
Appliance stops
working suddenly
Appliance stops
operation suddenly
(for DN630 only)
8
DM070 (+DN630)_ML_A5_v2_20241113.indb 8
DM070 (+DN630)_ML_A5_v2_20241113.indb 8
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Safety interlock system is
functioning due to improper
assembling
Overheating protection is activated
due to overload or short circuit
The appliance is equipped with
2 safety micro switches. These
switches, during operation, will
cut off the power supply under
2 conditions:
•
The pusher handle is lifted
backward
•
The cover is opened
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check mains power supply
Assemble the appliance correctly, referring to
section "Assembly"
1. Turn off and disconnect from power
supply
2. Empty the bowl and allow cooling down
for about 10 minutes
3. Restart the appliance
•
If Power OFF due to handle lifting, simply
lower the handle to restart
•
If Power OFF due to cover opening, close
the cover in place then press Start button
to restart.
2024/11/13 10:12
2024/11/13 10:12