Publicité
1. Safety Measures
Read carefully the operating instruction before assembling and starting.
•
The appliance must not be used by operators who are not thoroughly acquainted
with the instructions handbook (operating instructions). Moreover, the appliance
must not be used by persons under the age of 16.
The user is liable towards third parties in the area where the appliance is in
•
operation.
Before starting it is necessary to make sure that there are the necessary
•
electrical protection measures, by means of a test carried out by a specialist.
While the pump is operating persons must not be in the liquid to
be pumped.
The pump may be connected only by means of a safety switch for fault
currents, with a rated opening current up to 30 mA and a socket with an
earth contact installed in compliance with the regulations. Protection: at
least 10 Amps.
Operation in swimming pools and garden ponds is not recommended.
For other operation, the provisions in conformity with the standard VDE 0100
part 702 must be respected.
CAUTION: Before checking, connect the pump and the system with no
voltage!
Replacing the connecting up line requires using special tools and therefore
this must carried out by the manufacturer or its service engineers.
The pump may only operate with a pipe connecting the appliance (extension)
that is no lighter than a rubber hose mod. H07 RNF in compliance with the
DIN 57282 or DIN 57245 standard.
The noise (continuous equivalent in dbA) of the motor-driven pump is
•
less or equal (≤) to 70 dbA.
The voltage (230 Volts alternating current) indicated on the pump' s rating
•
plate must correspond to the available mains voltage.
The temperature of the liquid conveyed must not exceed 40°C.
•
Make sure that the plugged electrical connections are in an area safe from
•
flooding and are protected from humidity.
Before use it is necessary to check that the plug and the mains connection line
•
are not damaged.
Unplug from the mains before performing any work on the pump.
•
Avoid directly exposing the pump to the jet of water.
•
The user is responsible for complying with the local regulations for assembly
•
and safety.
The user by taking appropriate measures (e.g. installing an alarm, reserve pump
•
and the like) will have to exclude the possibility of indirect damage caused by
flooding premises due to failure of the pump.
12
Publicité
