Publicité
DocuSign Envelope ID: CAABFD13-50FF-4086-B5E0-EC6357CBAD11
(1)
The manufacturer declares herewith declares that the equipment is in conformity with the relevant Union harmonization legislation.
(2)
Equipment type
(3)
Applicable Directives
(9)
Notified body
(10)
This partly completed machinery must not be put into service until the final machinery in which it is to be
incorporated has been declared in conformity with Directive 2006/42/CE on Machinery.
Sames is allowed to compil the technical documentation.
Sames undertakes to transmit, in response to a reasoned request by the national authorities, relevant information
on the partly completed machinery in the most appropriate form. This declaration of incorporation of
partly completed machinery and this declaration of conformity are issued under the sole responsibility of the
manufacturer.
Director of the STAINS site - Executive Management (EM)
Hervé WALTER
Established in Stains, on
Siège Social / Headquarter: 13, chemin de Malacher - CS70086 - 38243 Meylan Cedex - France - Tél / Phone: +33 (0)4 76 41 60 60
The essential health and safety requirements mentioned in the Directive 2006/42/CE on
2006/42/CE
Machinery have been applied.
Articles: 1.1.5 ,1.1.6, 1.3.1, 1.3.2, 1.3.4, 1.5.1, 1.5.2
That partly completed machinery is also in conformity with the provisions of
(5)
2014/34/UE
(6)
Marking
(7)
Harmonised
standards
Conformity
(8)
assessment
procedure
2014/30/UE
2014/35/UE
2012/19/UE
25-nov.-22 | 08:19 CET
SAS au capital de 12.720.000 euros | RCS Grenoble: 572 051 688 | Code APE: 2829B | TVA intracom: FR36 572051688
DECLARATION OF INCORPORATION
OF PARTLY COMPLETED MACHINERY
EU DECLARATION OF CONFORMITY
Electronic Dosing System Cyclomix® Evo
(4)
The relevant technical documentation was compiled
as specified in annex VII, part B.
Electronic Dosing System
II 2G Ex h IIB T4 Gb X => dosing system in ATEX Zone
II (2)G Ex[ia Gb] IIB => piloting box outside of ATEX zone
Equipment
Zener barrier
Electrovalve ATEX
Sensor element ATEX
Mass Flowmeter
Pressure sensor
Fiber optic amplifier sensor
Each individual electrical component used in zone 1 is in
conformity with the 2014/34/UE directive. Their combined
presence in the assembly hasnothighlighted any additional risks
that would necessitate a comprehensive assesment of this type
of machinery.
EN ISO 80079-36 : 2016
EN ISO 80079-37 : 2016
EN 1127-1 : 2019
Module A Technical documentation (Annex VIII)
Electromagnetic Compatibility Directive
Low Voltage Directive
Waste Electrical and Electronic Equipment (WEEE)
INERIS 0080 – 60550 Verneuil-en-Halatte – France – INERIS-EQEN
/ n° INERIS-CERN 038002/ 22.
Sames
1
LCIE 12 ATEX 3005 X
BVS 17 ATEX E 074
Cylinder
BVS 17 ATEX E 041
Approval N°
BAS 01 ATEX 7005
BVS 08 ATEX E 101
21 ATEX 0036
SEV 11 ATEX 0129
DEC EU 578156130
Publicité
