Publicité
you can order a new one from your dealer.
Cut a piece of repair material large enough to
overlap the damaged area by approximately
12mm / 1/2", and round off the edges. Apply our
glue to the under side of patch and around the
area to be repaired. Too much glue will interfere
with a proper repair. Allow adhesive to become
tacky for 2-4 minutes, and then place patch
on the damaged area. Use a weight to apply
3-5 lbs. of pressure for 12 hours. After patch
has dried, apply glue around the edges for a
complete seal (dry 4 hours).
4. Large and Difficult Repairs
If you have a difficult repair, contact customer
services and we will advise you on the best way
to fix your boat.
5. If you see water coming into the boat,
check the following:
- Is the drain valve open?
- Is the diaphragm in the drain valve working
properly?
- Has it rained recently?
- Is there a hole in the floor?
Warranty Registration
You can register a warranty for this product
online at the Fox website - www.foxint.com.
Log in or create an account to start the
registration process. You will need the product
code, date of purchase and place of purchase
to complete the registration. After registration
make a note of your Customer Reference code
to view warranty details via your Fox website
account.
The warranty does not cover the following:
• Over inflation of tubes no more than
0.25bar/3.63psi
• Air loss due to temperature differences
• Air loss through the pressure valve in hot
conditions
• Folding marks. This is normal, and these will
disappear during use.
• Glue residue. All Fox boats are handmade and
the occasional glue mark may be visible.
UK
• Small imperfections on glued parts, which do
not affect the usability.
• Low air loss within 48 hours (up to 20% air
loss in comparison to operating pressure).
• Damage caused by the use of solvents of
any kind
• Damage caused by battery acid, oil and fuel.
• Damage caused by nail polish, suntan
lotion / oil.
• Damage caused by insect repellent.
• Damage caused by improper use.
• Damage caused by high pressure cleaning.
• Damage caused by the use of aggressive
cleaning agents.
• Damage caused by incorrect assembly and
disassembly of the boat.
• Damage caused by improper storage, poor
ventilation.
• Damage caused by inadequate cleaning and
maintenance of the boat.
• Damage in transit.
• Damage caused by use of pressure
compressors to inflate or deflate the boat.
• Damage due to normal wear and tear.
• Damage caused by use of force.
• Damage caused by animals on or in the boat.
• Damage caused by water in the tube interior.
• Damage to the hull as a result of
carelessness, as well as external influences.
• Damage caused by participation in racing
events of any kind.
• Damage caused by use of non-approved
accessories.
• Damage caused by exceeding the maximum
acceptable power KW / HP as well as the
permissible engine weight.
• Damage caused by exceeding the
permissible payload, and the recommended
number of people.
*Your statutory rights shall remain unaffected.
Publicité
