CARE FITNESS INTENSIVE Serie Mode D'emploi page 9

4.Installation of handlebar and conlloring panel
4.1Connect the Signal wire from Right upright tube to
corresponding wires from Handlebar.
4.2 Install handlebar and controlling panel set(6) to the Left/Right
upright tube (4/5).
4.3 Connect handlebar and controlling panel (6) to the Left/Right
upright tube (4/5) by 8 sets of Half-round bolt M10X20(A8),Spring
washerφ10(C5),Flat washerφ10(C2). (Attention: To align screw
hole)(See Figure 4)
5.Installation of display screen
5.1 Connect the signal wire from display screen to
corresponding wire from controlling panel. Crowding the
extra wire into the panel.
5.2 Connect the display screen (7) to handlebar and
controlling panel (6) by 4 sets of Half-round bolt
M10X20(A8),Flat washersφ10(C2).(Attention: To align
screw hole)(See Figure 5)
6. Installation of motor left/right cover
6.1 Tighten all the installation bolts
6.2 Install motor left cover (24) to top motor cover (23)
of base frame (1) by 1pc of Crosshead self-lock bolt
ST4X30 (A9) in front and 3pcs Crosshead self-lock bolt
ST4X16 (A17) to tighten.
6.3 Install motor right cover(25) to top cover(23) of base
frame (1) by 1pc of Crosshead self-lock bolt ST4X30
(A9) in front and 3pcs Crosshead self-lock bolt
ST4X16(A17) to tighten.(See Figure 6)
Treadmill adjustment
1.Before connect power, service or professional inspect if voltage is suitable, and if three-core plug grounded wire is
connected. Using hand to pull the belt, inspect if rotation is flexible and no noise.
2.Connect power, press Start key, treadmill will run slowly, inspect if belt and computer are normal.
3.Press incline +/- key, inspect treadmill rotation and display. If the belt is deviation, you must stop it to adjust belt
according daily maintenance.
4.Press the emergency button or remove the safety key to stop the treadmill immediately. After the safety key is
inserted again, the treadmill can be restarted only after the emergency button is reset.
5.Press Stop key, the treadmill stop to running, waiting incline back to zero class, turn off the power.