Publicité
GB
Please make sure there's enough space to install the treadmill and recommend 2 persons to install it.
WARNING: Don't insert the power wire until the treadmill was fully assembled.
Assembly tips:
1.In order to avoid instruction mistake, do not tighten bolt completely until the whole treadmill assembly is finished.
This treadmill packaged for 2 cartons. #1 carton is main frame.#2 carton is Handlebar and controller.
1. Opening the package and take the base frame out
Before the treadmill leave the factory, the frame and pallet
were fixed by holders and bolts. Using wrench to unscrew the
bolts (total 4pcs bolts) on frame, then take the base frame
out. (See figure 1)
2. Assembling left upright tube
A.
Install the Left upright tube (4) to base frame (1) using
four sets of bolt M10X25 (A4), Flat washersφ10 (C2) by side.
(Attention: to align screw hole with the upper surface). Make
sure the bolts to connect left upright tube and base frame.
(See figure 2)
B.
In upper inner side, using one piece Flat washer φ10
(C2) and one piece Nylon lock nut M10 (B4) to tighten. In
upper outer side, using Bolt M10X165 (A6) that was
assembled on frame to tighten.(Attention: bolt head position is
the front underside. See figure 2-1)
3.Installation of right upright tube
3.1Connect the Signal wire from right upright tube to
corresponding wires from frame.
3.2 Install the Right upright tube (5) to base frame (1)
using four sets of bolt M10X25 (A4), Flat washersφ10
(C2) by side. (Attention: to align screw hole with the upper
surface). Make sure the bolts to connect right upright tube
and base frame. (See Figure 3)
3.3 In upper inner side, using one piece of Flat washer
φ10 (C2) and one piece of Nylon lock nut M10 (B4) to
tighten. In upper outer side, using Bolt M10X165 (A6) that
was assembled on frame to tighten.(Attention: bolt head
position is the front underside. See Figure 3-1)
Publicité
