HumanTechnik lisa Mode D'emploi page 10

➡
It is only necessary to set units to
other channels if you have several
different users operating units in the
same building.
Set the channel you want by adju-
sting the channel selector switch on
the left-hand side of the unit to the
required channel number. Use a
small screwdriver to adjust this
switch.
All transmitters and receivers must
be set to the same channel.
3. Installing the alarm accessories
Plug the alarm accessories into the
socket on the underside of the Radio
Alarm Transmitter.
This socket is identified by a triangle
framing an exclamation mark:
Available accessories:
Alarm mat (A-2921-0)
Connect the plug from the alarm mat
directly into the socket in the
Alarm Transmitter (alarm accesso-
ries socket). Place the alarm mat
under the doormat.
Alarm call button (A-2935-0)
Connect the plug from the alarm call
button directly into the socket in the
Radio Alarm Transmitter (alarm
accessories socket). The alarm sig-
nal is triggered by pressing the but-
ton (e.g. from the patient's bed).
Water alarm sensor (A-2924-0)
Plug the water alarm sensor into the
socket of the transmitter marked
with a double wave. The water
alarm sensor is suitable for nearly
all fluids. Stick the sensor with the
supplied double-sided adhesive tape
to the wall so that the contacts
touch the floor. The signal is trigge-
red as soon as both contacts are
wetted by the fluid.
Radio