9. WARRANTY CONDITIONS:_____________________________________________________
9.1. GENERAL ASPECTS
9.1.1.
According to these provisions, the seller guarantees that the guaranteed product is in perfect condition upon delivery.
9.1.2.
The Total Warranty period is 2 YEARS.
9.1.3.
The Warranty period will be calculated as of delivery to the purchaser. The electrode is covered by a 2-YEAR
WARRANTY, which is not extendable.
9.1.4.
Should the Product be faulty and the seller is notified during the Guarantee Period, he shall repair or replace the
Product at his own cost wherever he sees fit, unless this is either impossible or out of proportion.
9.1.5.
When the Product cannot be repaired or replaced, the buyer may request a proportional price reduction or, if the fault
is important enough, rescission of the sales contract.
9.1.6.
Parts replaced or repaired pursuant to this warranty shall not extend the warranty period of the original Product,
although they shall have their own warranty.
9.1.7.
For this warranty to be effective, the buyer shall accredit the date of acquisition and delivery of the Product.
EN
9.1.8.
When the buyer alleges a fault in the product over six months after its delivery, he shall accredit the original and
existence of the alleged fault.
9.1.9.
This Warranty Certificate does not limit or prejudge consumer rights pursuant to national legislation.
9.2. SPECIFIC CONDITIONS
9.2.1.
For this warranty to be effective, the buyer must closely follow the manufacturer's instructions included in the
documentation supplied with the product, as applicable to each product range and model.
9.2.2.
Whenever a schedule is defined for the replacement, maintenance or cleaning of certain product parts or components,
the warranty shall only be valid when said schedule has been correctly followed.
9.3. LIMITATIONS
9.3.1.
This warranty shall only be applicable to sales to consumers, with "consumer" being defined as a person who purchases
the product for other than professional purposes.
9.3.2.
No warranty is applicable to normal wear or the product, parts, components and/or fungible or consumable materials
(except the electrode).
9.3.3.
The warranty does not cover cases in which the product: (I) has been incorrectly treated; (II) has been inspected,
repaired, maintained or handled by an unauthorised person; (III) has been repaired or maintained with non-original
parts, or (IV) has been incorrectly installed or started up.
9.3.4.
When a faulty product results from incorrect installation or start-up, this warranty shall only be applicable when the
installation or start-up forms part of the product contract of sale and had been performed by the seller or under the
seller's responsibility.
9.3.5.
Damage or faults due to any of the following causes:
l
l
l
l
Operation at salinity values of less than 3 g of sodium chloride per liter and/or water temperature lower than 15
or higher than 40
C.
o
Operation at a pH of more than 7.6.
Use of non-explicitly authorised chemicals.
Exposure to corrosive environments and/or ambient temperatures of less than 0
44
C
o
C or more than 50
C.
o
o