Publicité
5.4. Alarms
l
l
EN
l
HIGH SALT LEVEL
If too much salt has been added, the power supply will reduce the level of production
with regard to that which was selected automatically. The "SALT" [3] led will stay
on. In this case, empty part of the swimming pool (for example 10%), and add
fresh water to reduce the salt concentration. To know the exact level of salt, we
recommend the use of a portable salinity meter.
LOW SALT LEVEL
If the level of salt in the swimming pools water were below the recommended level,
the power supply may not reach the level of production selected. The "SALT" [3] led
will blink. It is possible that the system indicates salt levels below the real ones if
the water temperature is less than 24
end of its lifetime. In this case, determine the level of salt in the water and add the
amount of salt needed. The type of common salt (NaCl) indicated for salt electrolysis
should have no additives (anti-clogging agents, iodides) and should be suitable for
human consumption. To know the exact level of salt we recommend the use of a
portable salinity meter.
WATER LEVEL IN CELL/ FLOW DETECTOR (GAS)
If an air or gas bubble forms at any time at the top of the electrolysis cell and the
FLOW DETECTOR is not submerged, the system will automatically switch off
production and all of the leds of the control panel will blink. System automatically
resets when water flows through the cell again or the bubble disappear.
C or if the electrode package has reached the
o
Fig. 16
38
Publicité
