Publicité
otherwise kickback may occur. Investigate
and take corrective action to eliminate the cause
of wheel binding.
h) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool is
restarted in the workpiece.
i) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
j) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
ADDITIONAL SAFETY
RULES:
1. Always wear a dust mask.
GENERAL SAFETY
WARNINGS FOR YOUR
LASER
12
WARNING Read all safety warnings and
all instructions. Failure to follow the
warnings and instructions may result in
serious injury.
Save all warnings and instructions for future
reference.
These lasers do not normally present an optical
hazard although staring at the beam may cause flash
blindness.
Do not stare directly at the laser beam. A hazard may
exist if you deliberately stare into the beam, please
observe all safety rules as follows:
1. The laser shall be used and maintained in
accordance with the manufacturer's instructions.
2. Never aim the beam at any person or an object
other than the work piece.
3. The laser beam shall not be deliberately aimed
at another person and shall be prevented from
being directed towards the eye of a person for
longer than 0.25 seconds area.
4. Always ensure the laser beam is aimed at a
sturdy work piece without reflective surfaces, e.g.
wood or rough-coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar is not
suitable for laser applications as the reflective
surface may direct the laser beam back at the
operator.
5. Do not change the laser device with a different
type. The manufacturer or an authorized agent
Lithium-Ion Cordless Circular Saw
must carry out repairs.
6. CAUTION: Use of controls or adjustments
other than those specified herein may result in
hazardous radiation exposure.
ADDITIONAL SAFETY WARNING FOR CLASS 2
LASER
The laser device fitted to this tool is CLASS 2
with a maximum radiation of 1.5mW and 650nm
wavelength.
CLASS 2 LASER RADIATION, DO NOT STARE
INTO BEAM
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred cells
or battery pack.
b) Do not short-circuit a battery pack. Do
not store battery packs haphazardly
in a box or drawer where they may
short-circuit each other or be short-
circuited by conductive materials.
When battery pack is not in use, keep it away
from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects,
that can make a connection from one terminal to
another. Shorting the battery terminals together
may cause burns or a fire.
c) Do not expose battery pack to heat or
fire. Avoid storage in direct sunlight.
d) Do not subject battery pack to
mechanical shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has
been made, wash the affected area
with copious amounts of water and
seek medical advice.
f) Seek medical advice immediately
if a cell or battery pack has been
swallowed.
g) Keep battery pack clean and dry.
h) Wipe the battery pack terminals with a
clean dry cloth if they become dirty.
i) Battery pack needs to be charged
before use. Always refer to this
instruction and use the correct
charging procedure.
j) Do not maintain battery pack on
charge when not in use.
k) After extended periods of storage,
EN
Publicité
