Publicité
LED indicator / Beeper
Fig.6
► 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Check of the LED indi-
cator, lamp and beeper
operation
Detection of switch
trigger operation when
installing battery
Auto-stop with fastening
completion
Alarm against insuffi-
cient fastening
Intermission between
the phases
Double-hitting detection
Alarm for low battery
capacity
Auto-stop with low
remaining battery
capacity
Anti-reset of controller
Status of the tool
When the battery car-
Lights up first in green,
tridge is installed, the
next red.
tool checks for its LED
(And then the lamp
indicator, lamp and
comes on.)
beeper.
When the battery car-
Blinks in red and green
tridge is installed with
alternatively.
the switch trigger pulled,
the tool stops to avoid
unintentional start.
The tool setting has
Lights up in green for
been achieved and the
approximately one
tool has stopped.
second.
The tool has not com-
Lights up in red.
pleted the tool setting
because the switch
trigger has released
before reaching the
set values. Otherwise,
the settings of "Failure
Criteria for Phase" has
been achieved.
The tool is in the inter-
Lights up or blinks in
mitting period configured
green (depending on
by the setting of "Shift to
settings)
the next Phase".
When the operator
Lights up in red.
starts to re-fasten an
already-fastened screw,
the tool detect it and
stops.
The battery power
Blinks in red slowly.
became low and it is
time to replace the
battery cartridge.
The battery power is
Lights up in red.
almost used up and the
tool stopped.
The battery voltage
Blinks in red and green
dropped abnormally for
alternatively.
some reason, and the
tool stopped.
1
Status of the LED indicator/beeper
LED indicator
A series of very short
beeps
A series of short beeps
A long beep
A long beep
A series of long beeps
A long beep
A series of short beeps
8 ENGLISH
Action to be taken
Beeper
Release the switch
trigger.
–
Retighten the screw.
–
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
–
–
–
–
Publicité
