3. FUNCTION
The settings can be adjusted when the control
panel is removed. You can change the settings
or move to the next setting by turning the outer
wheel. Pressing the
respective input. Pressing the button for a mini-
mum of 3 seconds locks or unlocks the display.
Time
Connected
sensor
Start Time
(0 – 23) hrs (0-59) min.
Run Time
(0 – 29) sec.
(0 – 99) min.
ON
Frequency
4, 6, 8, 12, 24,
ON
48, 72 hrs
*
max. 1 year
If you will be away for long periods of
min. 4 weeks
time, please replace the battery when
the battery symbol blinks – otherwise
max. 4 weeks
the watering system may fail.
6
GAR_1890-28.960.08_2023-11-13.indb 6
GAR_1890-28.960.08_2023-11-13.indb 6
v (Fig. F)
button confirms the
Active
Watering
Battery
Condition *
Sensor
Soil Moisture
0 – 3 drops =
very dry /
rather dry /
min
sec
humid /
very humid
hrs
OFF
Timeplan
active /
deactive
too weak for opening again
4. PROGRAMMING
Fig. G:
1 Set time (hours) | 2 Set time (mins) |
3 Select schedule | 4 Confirm schedule
Please note: If starting in the past and at a fre-
quency of 4, 6, 8, 12 hours, the start time will
be automatically adjusted after input.
Watering tip: For pot plants that required small
amounts of water at regular intervals, short water-
ing cycles are ideal in combination with a drip
irrigation system.
The saved watering schedule can be activated or
deactivated by pressing ON / OFF.
Fig. I:
1 Active watering | 2 Change watering duration |
3 Stop active watering at any time
By pressing the
button, manual watering
can be started or stopped at a desired time
(see fig. I ).
Soil Moisture Sensor v (Fig. D and H):
After a soil moisture sensor is connected, the
word "Sensor" will be displayed – this can take
up to 1 minute.
Once the soil is sufficiently moist, a watering opera-
tion as per schedule will not be carried out.
This does not affect active (manual) watering.
Soil Moisture Sensor, Art.1867
(optionally available)
1 Connecting the sensor
An operating point must then be defined.
v (Fig. G – I)
9
13.11.23 15:16
13.11.23 15:16