Dometic Waeco CoolPower EPS100W Instructions De Montage Et De Service page 18

Mounting the mains rectifier

If you wish to mount the mains rectifier in a fixed position, please observe the

following mounting instructions:

 Do not mount the device

– In wet or damp environments

– In the vicinity of combustible materials

– In areas where there is a danger of explosions

 The place of installation must be well-ventilated. A ventilation system

which is at least equivalent to the air openings in the device must be pre-

sent for installations in closed housings.

 The air intake on the underside or the air outlet on the back of the device

must remain clear.

 The installation surface must be level and sufficiently sturdy.

➤ Secure the mains rectifier with the fastening bracket (fig. 2, page 3).

Using the mains rectifier

NOTICE!

 Do not reverse the polarity. If the poles are reversed device may

overheat and be damaged.

 Replace defective fuses with new ones of the same rating (4 A

slow-blow).

➤ Fit wire sleeves to the ends of wires which you wish to connect to the

mains rectifier.

NOTE

To avoid drops in voltage and therefore performance, keep the ca-

ble route as short as possible and only disconnect it when neces-

sary.

CoolPower EPS100W