Publicité
CoolPower EPS100W
2.2
Safety when installing the device
CAUTION!
!
Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
NOTICE!
A
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur.
Have the inverter installed by a specialist (marine) electrician.
Electrical cables
CAUTION!
!
Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
A
If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12 V DC cable in the
same duct!
Fasten the cables securely.
EN
General safety instructions
15
Publicité
