Startup; Connect The Power Cord - Hach 2200 PCX Manuel D'utilisation

Figure 9 Analog output wiring
1 Analog input card
2 Jumper position (internal loop power)
3 Jumper position (external loop power)
4 Interconnect card

Startup

Connect the power cord

Connect the power cord to an electrical outlet with protective earth ground.
Status indicator light and count display window
When the instrument is set to on, the status indicator lights on the front panel show. In operation, the
count display window shows the particle count. Refer to
16 English
5 Optional external loop power, 15-24 VDC (150 mA)
6 Wires from analog output terminals (OUT0-OUT7)
7 Analog connections on PLC, SCADA
Figure 10 and to Table 1.