Publicité
To remove the used lancet, remove the lancet from the
lancing device after you have finished testing. Discard
your used strip and lancet properly in a puncture-resistant
container.
Important!
The used lancet and test strip may be biohazards. Please
consult your health-care provider for proper disposal which
complies with your local regulations.
Reviewing Test Results
Your device stores the 450 most recent test results along with
respective dates and times in its memory. To enter the device
memory, start with the device switched off.
To review all test results, do the following:
1. Press and release MAIN. The "
screen.
2. Press MAIN to review the test results stored in the device.
Press MAIN repeatedly to review other test results stored
in the device. (r) After the last test result, press MAIN again
and the device will be turned off.
To review the day-average test results, do the following:
1. Press and hold MAIN for 3 seconds until the "
appears. Release MAIN and then your 7-day average result
measured in general mode will appear on the display.
" icon appears on the
" icon
2. Press MAIN to review 14, 21, 28, 60 and 90-day average
results stored in each measuring mode in the order of Gen,
AC, then PC. (s)
Note:
• Press and hold MAIN for 5 seconds to exit the memory
mode or leave it without any action for 3 minutes. The
device will turn off automatically.
• If using the device for the first time, the "---" icon will appear
when you recall the test results or review the average result.
This indicates that there is no test result in the memory.
• Control solution results are NOT included in the day
average.
Announcement of Memory Result by
Universal Tone
Only the most recent result that was saved can be announced
acoustically. If you press MAIN to turn the meter on, you will
first hear the Long-Beep which stands for power-on and then
the most recent result.
Only the average for the last 7 days is announced acoustically.
If the 7-day average cannot be calculated, three horizontal
bars are displayed. This is signaled acoustically with 3 long
beeps representing 3 zeroes.
EN-9
Publicité
