Cut The Fabric; Secure The Fabric - Petsafe HBK19-11925 Instructions De Montage

Cut the Fabric

Step
7
Gather (Quantity):
(5) Clips
(1) Tension Rod
1. Stretch the fabric as tightly as possible
to the corner post and select a fabric
wire to cut, allowing 4 inches (10 cm)
for the tension rod and clips (7A).
2. Cut the fabric by holding the fabric
loosely while you spin one of the
pickets out.
a. Undo the knuckle at the top and
the knuckle at the bottom of the
same picket (7B).
b. Unweave that picket by spinning
it out (7C).
c. Install the tension rod (7D) and
5 clips (7E).

Secure the Fabric

Step
8
Beginning at the gate opening, attach a tie wire to every 5th diamond around the top
(8A) and every 3rd diamond around the bottom (8B) of the dog kennel/dog run. Use
any extra tie wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if you temporarily raise the bottom of the
dog kennel/dog run onto bricks, blocks of wood, or the box that the dog kennel came in.
Tip: Zip Ties can be added for extra reinforcement.
• Steel tubes may
have sharp edges.
Use care during
fabric installation and
installing clips as wire
ends may be sharp.
• It is recommended that
work gloves be worn.
Pet may escape or become trapped in loose chain link fabric. Be sure
that the fabric is stretched tightly and securely. If properly stretched,
there should not be any slack in the fabric.
International Customer Care information: visit www.petsafe.net
7A
Remove this picket
4 inches
(10 cm)
7C
7B
7D
7E
8A
8B
9