Cut The Pet Door Opening; Drill Holes For The Frame - Petsafe Pet Door Guide D'installation

Cut the pet door opening

NOTE: When drilling holes and cutting the opening for the pet door, wear safety glasses and make sure to hold the
drill and jigsaw with both hands and at a 90-degree angle to the door.
8. Drill 1/2-inch (12-millimetre) holes just inside the corners of the drawn template (F).
These will be the pilot holes for the saw blade.
9. Cut between the holes you just drilled, along the drawn template lines (G).
F

Drill holes for the frame

10. Place the interior frame (the frame with one flap) in the opening and mark the screw holes (four holes for the
medium and large pet doors, six holes for the x-large pet door) (H).
11. Remove the frame and drill 1/4-inch (7-millimetre) holes in the marked locations (I).
H
6
G
I
petsafe.com