Cut The Fabric; Secure The Fabric - Petsafe Do-It-Yourself Dog Run Instructions De Montage

Step

Cut the Fabric

8
1. Gather 5 clips and 1 tension rod.
2. Stretch the fabric as tightly as possible to the corner post and select a fabric
wire to cut, allowing 11 cm for the tension rod and clips (8A).
3. Cut the fabric by holding the fabric loosely while you spin one of the pickets out.
a. Undo the knuckle at the top and the knuckle at the bottom of the
same picket (8B).
b. Unweave that picket by spinning it out (8C). Be careful! Wire ends
are sharp.
c. Install the tension rod (8D) and 5 clips (8E).
Repeat Steps 6-8 using the second roll of fence fabric. Start again at the
other gate post. You will use the remaining 2 tension rods and 10 clips to
complete these steps.
8B
________________________________________________________________________________________________

Secure the Fabric

Step
9
Beginning at the gate opening, attach a tie wire to every 3rd diamond around the top
(9A) and every 5th diamond around the bottom (9B) of the Dog Run. Use any extra tie
wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if you temporarily raise the bottom of the Dog
Run onto bricks, blocks of wood, or the box that the Dog Run came in.
Important: Please, for your pets safety, train your pet to become accustomed to his
new home. Consult a professional for help.
8
8C
www.petsafe.net
8A
Remove this picket
11 cm
8D
8E
9A
9B