Cleanmaxx EC813E-1250 Mode D'emploi page 24

EN
– remove the dust bag (18) if necessary,
– pull the wet fi lter (19) over the motor unit in the lid,
– place the lid (7) back on.
3. Select the nozzle you want and plug it onto the suction tube (see the "Attaching /
Removing Suction Nozzles" section).
Caution! The fl oor nozzle is not suitable for wet cleaning!
4. Unwind the mains cable and insert the mains plug into a properly installed mains
socket that is easily accessible.
5. Move the operating switch (6) to the I position to switch on the device.
6. Guide the nozzle over the surface to be cleaned or the liquid to be sucked up. The
device can be pulled along like a carriage during vacuum cleaning.
7. After the wet or dry cleaning, move the operating switch (6) to the 0 position to switch
off the device.
8. Remove the mains plug from the plug socket. Wind up the mains cable.
9. If you have sucked up liquids, the dirty water and dust container (9) needs to be emp-
tied (see the "Cleaning the Device" section).
Use With Shampooing Function
CAUTION!
■ Only ever pour the cleaning agent supplied with the device or standard carpet clean-
ing products for carpet cleaners into the fresh water reservoir.
■ Do not use any cleaning products that produce a lot of foam as excessive foaming
impedes the functioning of the device.
■ Make sure that the device does not tip over. The water from the water reservoirs
could spill out. To park the device, move the handle to the vertical position in which
it engages.
■ Do not wet the carpet excessively.
Preparing the carpet
1. Thoroughly vacuum the carpet which is to be cleaned. Do this using the fl oor nozzle
(see the "Use as Wet or Dry Vacuum Cleaner" section).
2. If possible, remove all furniture from the carpet. In the case of large items of furniture
which cannot be moved to one side, place the plastic fi lm below or around the feet
and only remove it once the carpet has completely dried after it has been cleaned.
The feet could be damaged by the moisture from the carpet.
3. Check the colourfastness of the carpet. Soak a piece of white fabric with the
cleaning solution supplied (see the "Filling Fresh Water Reservoir" section) and rub it
carefully on an inconspicuous spot on the carpet. If the white fabric does not change
colour, you can clean the carpet with the device. In the case of carpets that have
several colours, test the fastness of each colour.
Preparing the device
1. Remove the lid (7) (see the "Attaching / Removing Lid" section) and pull the wet fi lter
(19) over the motor unit on the lid.
09707_DE-EN-FR-NL_A5_V1.indb 24 09707_DE-EN-FR-NL_A5_V1.indb 24
24
04.01.2016 08:28:48 04.01.2016 08:28:48