Publicité
Fat percentage reference table
Adult body mass index(BMI) reference table
5. Hand pulse test
5.1 After and before exercise, can monitor exercise's pulse of static and dynamic. The pulse will be restore after
finished exercise. Exerciser hold the left and right hand touch pulse monitored metal, show pulse on screen. (Warm
tip: the max pulse value do not over (220-age) when exercise. If over the max pulse, suggest to rest for 30 minutes,
or reduce speed and incline. The test result is just for your exercise reference.)
6. Play music
6.1 Audio input
Using audio wire to connect treadmill audio interface 3.5mm and audio source (Mobile phone and tablet computer),
the treadmill play audio from other audio source.
6.2
Local music playing
Put U disk into right USB interface to play the music from U disk.
6.3
Application connection
Copy the link here under to your brower (Edge, Firefox, Chrome, Safari etc)
https://cloud.carefitness.com/index.php/s/E2WD22KMNBQzERL
And Follorw the detailed instruction
Maintennance and malfunction treatment
1．Clean: The surface of the treadmill should be kept clean, pull
out the power cord before cleaning. You can clean the running
belt and the surface of the treadmill with a soft and wet cloth, be
sure not to use strong solvents.
2．Adjustment of belt deviation: The running belt has been
adjusted when manufactured; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting,
(see figure)adjust theleft and right bolts in rear roller with
wrenchIf the belt deviates to the left, clockwise rotate the left
bolt. If the belt deviates to the right, counterclockwise rotate the
right bolt. It is better to adjust 1/2 circle at a time. After
adjustment, turn on the power and start the treadmill to check if
the belt back to certer at speed of 4-5km/h, repeat the
procedure if not.
3．Adjustment of belt slip: After a certain time of using, the belt might turn to be longer or couldn't free
Your should adjustthe left and right bolts in rear roller clockwise at same position till it runs smoothly and freely, it is
better to adjust 1/2 circle at a time .But to avoid shortening belt using lifetime, do not adjust it too tight.
4．Lubricate
When the lubricant between the running board and the running belt is used up, please lubricate the running board
and adjust the running belt well.
4.1Power off, loose the belt by using the method of belt deviation adjustment, then brush lubricant to the running
board evenly.
4.2 Please do not lubricate excessively,
service life of the treadmill.
lubricant is not the more the better, reasonable lubrication can improve the
roll..
Publicité
