Fracarro FRPRO 06 Instructions D'emploi page 34

Notes: A cluster, once activated, is associated to the UHF input you are programming. To change the default
configuration, select INPUT in the menu INPUT UHFx- CELLy.
All clusters are off by default. To enable the cluster, set the channel type (analogue or digital) from the "INPUT
UHFx – CELLy – CHANNEL TYPE" menu.
Follow the instructions above to program all clusters.
Clusters associated to other inputs
The clusters can be associated to three inputs UHF1 or UHF2 by means of a flexible matrix (see fig. 2.1);
therefore, it is possible to see the settings of the cells associated to other inputs by entering the menu of an
input.
Menu relevant to
the UHF2 input
Cluster associated
to the UHF1 input
By selecting the cluster shown in the previous figure, you can enter the settings of the cell. The settings are
displayed as shown in the following menu:
Cluster number 6
Start channel of cluster
5.3.2 PROGRAMMING THE B.III – FM – AUX INPUTS
For the B.III, FM and AUX inputs it is possible to regulate the gain from 0 to 20dB by entering the INPUT
SETTINGS menu and selecting the input you want.
CELL 1 - UHF 2
E21 : E21 - OFF
Start channel of cluster
UHF 2
<DDDD11>
CELL 6 - UHF 2
E33 : E37 -
Finish channel of cluster
B.III INPUT B.III – GAIN
0
B.III – GAIN
20
FM FM – GAIN
INPUT 0
FM – GAIN
20
AUX AUX – GAIN
INPUT 0
AUX – GAIN
20
Cluster off
Finish channel of cluster
E33 - E37
06
Indication of the number of
clusters you are programming
Menu relevant to
the UHF1 input
Cluster associated
2
to the UHF2 input
Setting the gain of the B.III
To select
Setting the gain of the FM
To select
To select
34
+DAB input
00 dB
01 dB
...
20 dB
input
00 dB
01 dB
...
20 dB
Setting the gain of the AUX
input
00 dB
01 dB
...
20 dB