Fracarro FRPRO 06 Instructions D'emploi page 33

ATTENTION: the following instructions are based on more fl exible input, the UHF2 input.
Enter the "INPUT – UHF2" menu to program all clusters (to select a different input, use the UP/DOWN arrows
from the INPUT menu). The following will appear:
Indication of the input you
are programming
D: cluster with Digital channels;
A: cluster with Analogue channels;
X: cluster off;
_: the cluster cannot be selected for this UHF input
E: cluster in Error (possible overlapping of channels with other clusters);
d : cluster with Digital channels with a low input level (visible only after self-alignment);
a : cluster with Analogue channels with a low input level (visible only after self-alignment).
If the cluster is associated to a UHF input that is different from the input you are programming:
1: cluster associated to the UHF1 input;
2: cluster associated to the UHF2 input;
X: cluster off;
E: cluster in Error (possible overlapping of channels with other clusters);
Clusters associated to the selected input
Use the left/right arrows to select the cluster to program.
Start channel of cluster
The selected cluster fl ashes
The selected cluster will fl ash. Press the
menu:
Cluster number 1
Start channel of cluster
Press the key again to enter the setting of the cluster's initial channel and end channel. To set the cluster's key again to enter the setting of the cluster's initial channel and end channel. To set the cluster's
initial channel, use the up/down arrows and the digit keyboard to enter the channel number. Press the
to confi rm and then set the cluster's end channel.
A cluster may contain a minimum of 1 channel and a maximum of 6 channels.
Using the up/down arrows, the clusters can be enabled:
• setting the channel type (analogue, digital, OFF),
• setting the association of the cluster at the UHF input (not available for the fi rst 4 clusters because they
can only be associated to the UHF2 input),
• regulate the cell gain (if enabled).
UHF 2
<XXXXXX> --
Indicate the 6 clusters in the Profi ler
UHF 2 E21 - E21
<DDDDDD> 01
key to enter the cluster programming and display the following
CELL 1 - UHF 2
E21 : E21 - DTT
Finish channel of cluster
33
Finish channel of cluster *
* if the cluster is
enabled
Indication of the number of
clusters you are programming
UHF2 antenna input
associated to the cell 1
Channel type:
DTT: Digital
A: Analog
OFF: cluster off
key