Publicité
Switch the laser (14) on by means of the laser on/off switch (13). If you press again the LED
light works and if you press a 3
▪
Place the machine on the workpiece with the saw marking above the start of the cutting
line.
▪
Check that the laser line aligns with the cutting line as marked on the workpiece.
▪
Switch on the machine.
▪
Follow the "instructions for use" to perform a cut.
▪
After use , switch off the laser.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
10.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2
Lubrication
From time to time, apply a drop of oil to the thread of the lock screw (18).
11 TECHNICAL DATA
Voltage / frequency
Power input
No load speed
Saw blade
Max. depth of cut 90°
Max. depth of cut 45°
Mitre angle
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
▪
The specified total vibration values and the specified noise emission values were
measured according to a standardised test method and can be used to compare one
power tool with another.
Copyright © 2022 VARO
POWX0520
rd
time, the LED light as well as the laser will work.
230-240 V / 50 Hz
1500 W
5500 min
Ø 185 x Ø 20 x 2.4 mm
64 mm
48 mm
0 – 45°
104 dB(A)
115 dB(A)
2,4 m/s²
P a g e
-1
K = 1.5 m/s²
| 8
EN
www.varo.com
Publicité
