Publicité
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1
Operation instructions
Do not attempt to drill material with the surface other than flat
unless a suitable support is available!
Never switch the machine on while pressing the drill bit against the
material!
HOLZMANN MASCHINEN GmbH
LANGLOCHBOHRMASCHINE–MORTISING MACHINE-TALADRO HORIZONTAL-PERCEUSE HORIZONTALE- WIERTARKO - FREZARKA LBM 250C
Perform all machine settings with the machine being
disconnected from the power supply!
Before switching the machine on, make sure that the table-
clamping lever is firmly tightened
Make sure that the bit is firmly clamped in the chuck
Due to the height of its own weight is the fixation of the drill
press to the ground requirement for less-vibration work.
Before switching the machine on, make sure that the chuck
key is removed
Use a clip or clamping jaws to secure the piece to be drilled on
the table
www.holzmann-maschinen.at
W A R N I N G
A T T E N T I O N
N O T I C E
OPERATION
Seite 37
Publicité
