Publicité
light fixture
through which the mains cable
2
will be inserted.
Mark three drill holes for the screws
Drill the holes. Be sure not to damage the mains
cable (external)
4
Insert the wall plugs
If necessary, use a hammer to help you.
Guide the mains cable through the drill hole in
the light fixture
provided for this purpose and
2
attach the light to the ceiling.
Ensure that the grommet is securely in the drill hole.
Before the light is connected, the insulated ground
wiring must be prepared with an additional
insulation.
Pull the enclosed protective tubes over cables
L and N of the mains connection cable.
Note: Be sure to correctly connect the individ-
ual leads on the mains cable (external)
wire, black or brown = symbol L, neutral wire,
blue = symbol N, earth wire, green-yellow=
symbol
.
Install the plastic cover
match the cover's three notches to the corresponding
retaining bolts and press these upwards. Turn the
cover clockwise to fasten it.
Replace the fuse or switch on the circuit breaker
(I setting) inside the fuse box.
Your LED ceiling light with Bluetooth speaker is now
ready for use.
Installing the wall bracket
Install the wall bracket
using the screws
9
(see fig.).
Inserting/replacing batteries
Note: The remote control
batteries (included).
Press the cover of the battery compartment
(rear) down, slide it approx. 1 cm downwards
to open and lift off the cover.
Insert two of the included AAA batteries in the
battery compartment. Ensure correct polarity.
(see fig.).
6
.
into the drilled holes.
1
: live
4
of the light. To do this,
7
for the remote control
25
or the adhesive pad
26
requires two AAA
9
Replace the cover and push it back to close the
battery compartment.
Your remote control
Operating the light by switch
The LED ceiling light can be switched on and off
using the wall switch. The light intensity always
corresponds to the brightness level that was last
set. There should be at least 5 seconds between
switching off and switching on again via the
wall light switch. If the wall light switch is pressed
more quickly, the luminaire switches on at full
brightness. All other functions are controlled
solely via remote control
Using the remote control
ATTENTION!
The functions of the remote control can only be
used after switching the LED ceiling light
with the wall switch.
Switching the light on/off
1. Switching the light on
Press the "White light" button
white light on or off.
Press the "RGB" button
coloured light on or off.
27
Dimming the light
Switch the light on.
1. Increasing brightness
Press the "
the brightness. Briefly pressing this button will
gradually increase the brightness as pressed.
Holding the "
automatically increase the brightness to the
maximum.
is ready to use.
9
.
9
to switch the
24
to switch the
10
" button Dimmer +
, to increase
23
" button Dimmer +
23
on
9
will
GB/IE
23
Publicité
