Publicité
@ PICTURE control
Adjusts the contrast, color Intensity and brightness simultaneous-
ly in the proper ratio.
:
@ VOLUME control
Adjusts the volume.
@ PROJECTOR switch
Depress to turn the projector on. The green pilot lamp will light. To
turn off, press the switch again.
@ BRIGHT (brightness) contro!
Adjusts the brightness.
@ SHARPNESS control
;
Adjusts
the sharpness.
Clockwise
rotation
makes
the picture
sharp; counterclockwise rotation makes it soft.
@ COLOR contro}
Adjusts the color intensity. Clockwise rotation makes the picture
vivid; counterclockwise rotation makes It pale.
© HUE control
This control is effective only for a program of the NTSC or NTSC, 45
color system. Use to obtain the most natural skin tones. Clockwise
rotation makes the skin tones greenish; counterclockwise rotation
makes them purplish.
© V (vertical} HOLD control
If the picture rolls vertically, adjust this control until the picture
stabilizes.
© INPUT SELECT buttons
Press to select the program source to be projected.
LINE: For inputs from the LINE IN connectors
RGB: For inputs from the RGB IN connectors
If audio signals are connected to the LINE IN, the sound will
be heard.
@ BLUE MODE SELECT switches
This switch is effective only for RGB
inputs.
Usually set to NORMAL. Set to BB (blue background) to change the
black background of the display to blue, and to CB (clear blue) to
lighten blue part of the display.
The display should become easler to view.
@ NORMAUTEST switch
Usually set to NORMAL to project inputs from the LINE IN or RGB
connectors.
Set to TEST to display the built-in cross-hair pattern on the screen
for easier adjustments of the projector's position and registration.
@ V CENT (vertical centering) controls
Adjust vertical registration of red and blue.
@ H CENT (horizontal centering) controls
Adjust horizontal registration of red and blue.
connected
to the REMOTE
connector. The same controls on the
VPR-722 are operative.
Publicité
