Ribimex Ribiland PREHLS6R Manuel D'instructions Et D'utilisation page 36

Fig.7 Fig.8
4.3- Electrical requirements
With a 230V~ 50Hz motor, the log splitter should be connected to standard 230V±10% (50Hz±1Hz).
The electrical supply must be fitted with protection devices of under-voltage, over-voltage, and
over-current as well as a residual current device (RCD), which maximum residual current rated at
0.03A.
Electrical connection rubber cables must comply with EN60245 which are always marked with
2
H07RN-F, and with cross section greater than 1.5mm .
Wiring and Plumbing diagrams
For log splitter 6T PREHLS6SR / 042101 For log splitter 7T PREHLS71T/VE / 042111
Page 36 / 66