Electrolux EHF6547FOK Notice D'utilisation page 14

14
TROUBLESHOOTING
You cannot activate the
appliance or operate it.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
The appliance deacti-
vates.
The residual heat indicator
does not come on.
The Automatic Heat Up
function does not operate.
You cannot activate the
outer ring.
The sensor fields become
hot.
There is no acoustic sig-
nal when you touch the
panel sensor fields.
comes on.
comes on.
Problem Possible cause
You touched 2 or more
sensor fields at the same
time.
The Stop+Go function op-
erates.
There is water or fat stains
on the control panel.
You put something on
one or more sensor fields.
You put something on the
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting is
set.
The cookware is too large
or you put it too near to
the controls.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device or
the Lock function oper-
ates.
Remedy
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
Touch only one sensor
field.
Refer to the chapter "Oper-
ating instructions".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the cooking zone operat-
ed sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as the
Automatic Heat Up func-
tion.
Activate the inner ring first.
Put large cookware on the
rear cooking zones if nec-
essary.
Activate the signals (refer to
"OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Oper-
ating instructions".