Ditel RS2 Manuel De L'utilisateur page 30

OPTION RS2 ALPHA/GAMMA PROGRAMMING
The figure represents MODULE 5 for serial output configuration, valid for the ALPHA-P,
ALPHA-C, ALPHA-D and GAMMA-M models.
The module consists of 2 independent access menus that allow the configuration of the
following parameters:
• Menu 5A CnF : Setting the baud rate and address of the device.
• Menu 5B trAnS : Selection between ASCII, ISO 1745 and MODBUS protocols.
ACCESS TO PROGRAMMING THE SERIAL OUTPUT
Press the "ENTER" key to go from the work mode to the programming
mode (indication -Pro-, PROG led) and repeatedly press the key
until reaching the level shown in the figure corresponding to the entry in
the programming module of the serial output.
Press to access the different programming menus,
ENTER
: to go to the next programming module.
: to return to work mode.
ESC
The figure shows the indication corresponding to entering the transmis-
sion speed and address configuration menu
(display 5 CnF, leds A and PROG active).
ENTER
Press to enter this menu, or
: to go to the next programming module.
ESC
: to return to work mode.
KOSMOS SERIE
PRESSING THE
RUN MODE WITHOUT CHANGING THE PRE-
VIOUS PROGRAMMING
www.ditel.es
KEY RETURNS TO
ESC
PROG
A
B
RU
TARE HOLD LIMIT MAX MIN
N
INP1
PRG DSP1 INP2 DSP2 FLT
TARE RESET LIMIT MAX/MI
N
TEACH ESC
RS2
1
2
3
DATA
4
STORE
ENTER
DATA
30