Ditel RS2 Manuel De L'utilisateur page 27

OPTION RS2 BETA PROGRAMMING
The lower diagram represents MODULE 5 for serial output configuration, valid for BETA-M
model instruments.
The module consists of independent access menus that allow the configuration of the fo-
llowing parameters:
• Menú 51 -SoFt-
• Menú 52 -bAud-
• Menú 53 -AdrS-
ACCESS TO PROGRAMMING THE SERIAL OUTPUT
Press the "ENTER" key to go from the work mode to the programming mode
(indication -Pro-, PROG led) and repeatedly press the
reaches the level represented in the figure.
Press to access the first of the menus, or
ENTER
: To go to the next programming module.
: Return to programming access level (indication -Pro-).
ESC
PROTOCOL SELECTION
The figure shows the indication corresponding to the entry in the communica-
tion mode selection menu between the instrument and the D.T.E.
Press to access the first of the menus, or
ENTER
: to go to the next programming module.
: to return to the programming access level (-Pro-).
ESC
KOSMOS SERIE
: Protocol selection 1= ASCII , 2= ISO 1745 y 3= MODBUS.
: Device speed transmisión setting.
: Device address setting.
www.ditel.es
key until it
M
A
X
M
I
N
HOLD
TARE
M
A
X
M
I
N
HOLD
TARE
RS2
TARE RESET LIMIT MAX/MIN DATA
ESC ENTER
TARE RESET LIMIT MAX/MIN DATA
ESC ENTER
27
1
2
3
4
1
2
3
4