Ditel RS2 Manuel De L'utilisateur page 28

PROTOCOL SELECTION
The type of protocol previously programmed appears on the main display,
[prot1 = ASCII protocol, prot2 = ISO 1745 protocol and prot3 = MODBUS].
Press if you want to change the option present on the display
: to validate the selection and automatically pass to the -Pro- level.
ENTER
: to return to the programming access level (-Pro-).
ESC
SPEED TRANSMISSION SELECTION
The figure shows the indication corresponding to the entry in the transmission
speed selection menu.
Press to access this menu.
ENTER
If this parameter has been previously programmed and you want to go to the
next menu, press
An "ENTER" in the previous step makes the initially programmed baud rate ap-
pear on the main display.
Possible options are 1200, 2400, 4800, 9600, and 19200 baud.
Press the key successively until the option is displayed on the display
desired and press to validate the selection and automatically pass to
ENTER
the -Pro- level.
: to return to the programming access level (-Pro-).
ESC
DEVICE ADRESS SELECTION
Press "ENTER" to access the menu selection level and
instrument at the entry of menu 53 for address programming (see figure).
Press the key:
: to access the programming of this parameter, or
ENTER
: to return to the programming access level (-Pro-).
ESC
KOSMOS SERIE
twice to place the
www.ditel.es
M
A
X
M
I
N
HOLD
TARE
TARE RESET LIMIT MAX/MIN
ESC
M
A
X
M
I
N
HOLD
TARE
TARE RESET LIMIT MAX/MIN
ESC
M
A
X
M
I
N
HOLD
TARE
TARE RESET LIMIT MAX/MIN
ESC
RS2
1
2
3
4
DATA
ENTER
1
2
3
4
DATA
ENTER
1
2
3
4
DATA
ENTER
28