Publicité
Operation
Set the product on a solid, level and flat surface to
weigh.
Weighing
Note: Always place the object you wish to weigh
gently onto the weighing surface
ing the glass surface.
To activate the product, you may directly put a
load (e.g. food container) with minimum 250 g
onto the weighing surface
weighing surface
1
possible to activate the product. You can always
press the button TARE
zero point.
Place the item you wish to weigh onto the product.
The numerical display
the item you are weighing.
Incremental weighing
Touching the button TARE
will change the numerical display
reading to "0". The "T" symbol
Note: A slight touch of the button TARE
button UNIT
is sufficient to operate the product.
4
If there is too much pressure, the product may cause
tilting.
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
If you remove all items from the product, the LC
display
will show a negative value indicated
2
by the minus symbol
to avoid damag-
1
. Pressing onto the
1
with a certain force is also
at any time to set the
3
will show the weight of
7
with the product on
3
from the
7
will appear.
10
3
will show the weight of
7
will again read "0".
7
.
9
Then briefly touch the button TARE
symbol
Important! Be sure never to add more than 5 kg
to the weighing surface
can damage it.
Changing the measuring unit
The product will display the weight in the official Euro-
pean measuring unit "g" (grams), as well as the tradi-
tional unit of weight "oz" (ounce, 1 oz ≈ 28.35 g) or
"lb'oz" (pound: ounce, 1lb = 16 oz ≈ 453.59 g).
When measuring the volume of water, the product
calculates it by the weight using the official European
unit of volume "ml" (millilitres) or the traditional unit of
measure fl'oz (fluid ounces, 1fl'oz ≈ 28.41 ml).
To switch the unit of measure, briefly touch the UNIT
button
. After each time it is touched, the unit
4
display
will switch to the next unit listed:
8
Switching off
Holding the button TARE
and the
will off the product. If no movement is detected on
the weighing surface
is pressed, the product will automatically switch
off.
Troubleshooting
= Fault
= Cause
= Solution
will disappear.
10
. Overloading the product
1
g → oz → lb'oz → ml → fl'oz
for approx. 3 seconds
3
for 3 minute and no button
1
, and the "T"
3
GB/IE
19
Publicité
