Publicité
Safety / Initial use / Changing the light bulb
Never open or insert anything into electrical
fittings or equipment (e.g. switches, fitting socket).
This will pose a risk of fatal injury from electric
shock.
Only touch the insulated area of the mains plug
when connecting to or disconnecting from the
mains!
To prevent hazards, a damaged flexible outer
lead of this light may only be exchanged by
the manufacturer, his service representative or
by an equally qualified specialist.
Before every use, verify the available mains
voltage matches the required operating voltage
of the light (see "Technical data").
Always unplug the mains plug, respectively,
from the mains prior to assembly, disassembly,
cleaning, or when the light will not be used for
extended periods.
Do not install the lamp on a wet or conductive
surface.
Only insert the light bulb in a dry
environment.
This lamp is not suitable for external
dimmers and electronic switches.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the illuminant from a close
distance during operation.
Do not use optical instruments to look at the
illuminant.
In order to disconnect the light completely from
the power supply, the mains plug must be
removed from the socket.
Only use the light bulbs specified in the chapter
"Technical data".
14 GB/IE
Initial use
Mounting the lamp
Note: Remove all packaging materials from the
product.
Only 14150905L (see Fig. A):
Position the lamp with the screw clamp
the desired location.
Then tighten the screw
clamp
is securely fastened.
4
Only 14151005L / 14151105L
(see Fig. B / C):
Insert the lamp into the recess provided in the
base plate
.
7
Insert the weight
8
Important: Position the weight so that the
„TOP" marking points to the light.
Then screw the weight
washer
and the wing bolt
11
Remove the protective film from the bottom of
the furniture protecting foot pad
Now stick the foot pad
All models:
Use a clean, lint-free, dry cloth to insert the
bulb
.
3
Screw the light bulb
socket
.
2
Plug the mains plug
socket.
Your light is now ready to use.
Switching the light on / off
Switch the lamp on or off by pressing the in-line
switch
.
6
Changing the light bulb
Switch the lamp off.
RISK OF ELECTRIC SHOCK!
First unplug the mains plug
in
4
. Ensure the screw
5
into the base plate
.
7
tight using the
8
.
10
.
9
underneath the lamp.
9
clockwise into the lamp
3
into a properly installed
1
from the socket.
1
Publicité
