Publicité
Power supply
The scale is generally powered by batteries.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover.
Note: the scale is prepared for use
with a seca mains unit which is availa-
ble as an accessory.
The mains unit can also be used with
the batteries in place without the scale
or batteries being damaged.
4. Setting up and aligning the scale
– Place the scale on a level surface.
– Undo the locknuts using the four foot
screws (1).
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the
circle (2).
– Then re-tighten the locknuts (3).
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Important!
The alignment of the base of the scale must be checked and corrected if neces-
sary every time the location of the scale is changed.
20
Battery
compartment
1 .
2 .
spirit level
Libelle
3 .
Publicité
