Publicité
CAUTION
Pointer to a possibly dangerous
situation, which can lead to mi-
nor injuries.
ATTENTION
Pointer to a possibly dangerous
situation, which can lead to
property damage.
Description of the Appliance
When unpacking the product, make sure that no acces-
sories are missing and that none of the package con-
tents have been damaged. If you detect any transport
damages please contact your dealer.
Illustrations on fold-out page!
1
Container
2
ON/OFF switch
3
Suction hose connection
4
Storage compartment for mains cable
5
Carrying handle
6
Appliance head with clip closure
7
Storage for suction tubes and accessories
8
Mains cable with mains plug
9
Swivel casters
10 Suction hose
11 Suction tubes 2 x 0.5 m
12 Floor nozzle, reversible
13 Crevice nozzle
14 Upholstery nozzle
15 Cartridge filter (already installed in the device)
16 Filter bag
Commissioning and operation
ATTENTION
Always work with an inserted cartridge filter during wet
as well as dry vacuum cleaning!
Attaching the Accessories
Illustration
Remove the appliance head and take accessories
out of the container.
Illustration
Fit the swivel casters on the container bottom. In-
sert filter bag if required.
Illustration
Put the appliance head onto the container and lock
it.
Illustration
Connect accessories.
Illustration
Connect the mains plug and turn on the appliance.
Dry vacuum cleaning
ATTENTION
Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!
To vacuum fine dust, use the filter bag.
3x
Information filter bag
–
The filling level of the filter bag depends on the dirt
that is sucked in.
–
The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
–
Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
Working with the floor nozzle
Recommendation:
Use the floor nozzle to vacuum up dry dirt only.
Vacuuming carpeted floors
Illustration
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are retracted.
Vacuuming hard surfaces
Illustration
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of the
floor nozzle are extended.
Wet vacuum cleaning
ATTENTION
Do not use a filter bag!
Take fluids or shards up with the handle.
If necessary, the floor nozzle can be used with the
hard floor setting.
ATTENTION
The floor nozzle must dry completely after use, before it
can be used again for dry vacuum cleaning.
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Upholstery cleaning
Use upholstery nozzle to vacuum upholstered fur-
niture.
Illustration
The upholstery nozzle can be directly attached to
the handle or the connection piece.
Illustration
Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
Remove the appliance head and empty the reser-
voir.
Storing the appliance
Illustration
Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.
– 7
EN
Finish operation
11
Publicité
