Publicité
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
TROUBLESHOOTING.
PROBLEM
The wet/dry shampoo
vacuum will not operate.
The dust comes out from
the motor cover.
Low suction power and high
operating noise / vibrations.
Cleaning solution does not
spray out.
TROUBLESHOOTING
POSSIBLE CAUSE
Faulty power cord, switch, or motor.
No power supply.
On/Off switch is in the wrong
position. Or the correct mode
button is not selected.
Collection tank full.
damaged.
dry vacuuming.
damaged.
Nozzle, hose, or tank inlet is
blocked.
dust.
Float valve has closed.
Detergent mode is not selected.
Cleaning solution tank is empty.
The water pump inside the
powerhead overheats.
Unplug and check the power
cord. If damaged, have it
repaired by a professional or
call customer service.
Check the power supply, cord,
breakers, and fuses.
Press the ON 'I' button on
the powerhead and select
desired cleaning mode. Follow
instructions on page 12-17.
Empty the collection tank.
Attach or replace the cartridge
Attach or replace the exhaust
Check and remove blockage
from the nozzle, hose, and tank
inlet.
Empty the collection tank of
any liquid waste and ensure the
Press the detergent mode
button.
Ensure there are no kinks in
tubes.
Let the vacuum cool down to
reach a normal temperature,
then re-start the vacuum.
22
SOLUTION
Publicité
