Publicité
1
EMPTYING THE COLLECTION TANK
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWERHEAD FROM COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Press down the yellow latch on the cleaning solution delivery tube and unplug the delivery tube
from the vacuum. Then disconnect the hose from the vacuum (Fig. 2).
3. Disconnect the cleaning solution tube from the cleaning solution tank (Fig. 3).
4. Undo the latches and remove the powerhead from the collection tank (Fig. 4). Place the
powerhead on a soft, clean surface upside down.
5. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 5).
7. Check the hose, attachments, and power cord to ensure that they have not been damaged.
8. Place the powerhead back onto the collection tank and secure latches.
IMPORTANT!
CARTRIDGE FILTER FOR DRY VACUUMING.
NOTICE!
tears; replace it immediately.
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories
should be cleaned and stored so they can be readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
using only identical replacement parts.
MAINTENANCE
3
2
4
18
5
ALWAYS USE THE
Publicité
