Publicité
6. Insert the two rear casters into the slots and apply pressure until they click into place (Fig. 5).
7. Insert the handle into the slots located on the top of the powerhead and secure it with the
screws provided. Do not over-tighten the screws (Fig. 6).
page 19 for installation instructions (Fig. 7 & 8).
care not to damage the bag (Fig. 9).
NOTE: The dust collection bag is for dry pick-up only.
11. Position the hose storage rack as illustrated. Squeeze the open sides of the hose storage rack
inward. Insert the hose storage rack into the channel on the front side of the powerhead just
above the top edge of the tank. Verify that the rack is secured in place as shown in (Fig. 11 &
12). Then squeeze in the other hose storage rack and insert it into the corresponding channel
making sure it is secured.
12.Place the powerhead back on the collection tank aligning the top section with the latches, and
snap into place (Fig. 13).
14).
14. A cleaning solution delivery tube runs along the hose with a threaded connector at the end.
Insert the locking end of the hose into the vacuum port of the collection tank and turn clockwise
to lock it into place. Connect the threaded connector on the end of the delivery tube onto the
cleaning solution outlet coupling on the front of the powerhead (Fig. 15).
15.Lift the remote-control handle at the other end of the hose and insert the battery with the
terminals in the direction as shown (Fig. 16).
16. Position the battery cover at the angle of inclination as shown. Then insert it into the slot on the
battery compartment and press down the battery cover to click into place (Fig. 17 & 18).
17. Choose the desired accessory and/or the extension wand and connect it onto the remote-
to manually change the amount of vacuum suction (Fig. 20).
NOTE:
the suction power (Fig. 20).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
PROGRAMMING THE REMOTE-CONTROL HANDLE
NOTE: The programming of the remote-control handle has been preset and is ready to be used
in both vacuum and detergent mode. Reset the remote-control handle using the steps below if
unable to operate in vacuum mode.
1. Ensure the vacuum is plugged into the power outlet.
2. Switch the on/off switch to the "I" ON position.
3. Locate the detergent mode button on the powerhead indicated by the following symbol
4. Press and hold the detergent mode button until the indicator light illuminates continuously
(Fig. 21).
5. While the light is on, press and hold the detergent mode button on the remote-control handle
programmed to vacuum, and you should be able to operate in both detergent and vacuum
modes (Fig. 22).
① ) on the remote-control handle allows you
eliminates the need for the three-wire
11
.
Publicité
