Publicité
5. Place the powerhead back on the collection tank and secure it in place using the latches (Fig. 6).
OPERATING INSTRUCTIONS: DRY VACUUMING
6. Insert the locking end of the hose into the vacuum port on the collection tank and turn clockwise
to lock into place (Fig. 7).
7. Choose the desired accessory and connect onto the remote-control handle or the extension
wand (Fig. 8). The air flow regulation on the remote-control handle allows you to manually
change the amount of vacuum suction.
8. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 9 & 10).
Press the vacuum mode button, indicated by the following symbol
control handle or the powerhead and operate the vacuum (Fig. 11).
10.Once you have completed vacuuming, switch off the vacuum by pressing the vacuum mode
button on either the remote-control handle or the powerhead. Switch to the "O" OFF position
and unplug the power cord from the power outlet.
O = OFF
I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
DO NOT USE THE DUST BAG FOR LIQUID VACUUMING.
LIQUID VACUUM OPERATION
1
6
LIQUID VACUUMING
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUST IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUST INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
= VACUUM MODE
2
3
7
8
4
13
, on either the remote-
5
Publicité
