Resetting All Settings To Factory Settings - Sygonix IP65 Mode D'emploi

j) Resetting all Settings to Factory Settings
If you have forgotten the master code (or other user codes or the switching
code), or if you want to re-programme the code lock, you can reset the code
lock to the factory settings. All settings (master code, user codes, etc.) are lost.
Proceed as follows:
• Disconnect the code lock from the power supply for a few seconds.
• Connect the code lock to the power supply again. The Piezo buzzer emits a
few signals to indicate the start.
Push the key "#" 5 x during this time.
Example:
• The code lock now deletes all settings. This may take a few seconds.
Then the code lock is ready for operation in the factory settings; the factory
settings are as follows:
Master code:
User code:
Activation time for the relay:
Protection from incorrect input:
Operating mode:
Switching code:
36
The home technology brand for the entire house. More information at www.sygonix.com
1234
Memory slot 01 = 3333
5 seconds
Deactivated
Regular mode
Not present