Publicité
OPERATION
NOTES
When switching on, all settings, such as VOLUME and EQUALIZER, are loaded as they were set before
the speaker column was previously switched off. After a short time, the speaker column is ready for
operation.
After about 30 seconds without any input by rotary-push encoder, the display system leaves lower
levels in the menu structure and the main display with the VOLUME selection is automatically shown.
MAIN DISPLAY
In normal operation, the main display is activated, showing VOLUME with the current value, the set
delay and the number of satellites used. The Bluetooth status, the volume level (LVL), the gain (VOL)
and the status of the automatic equaliser (AUTO EQ) and the automatic satellite detection (AUTO DETECT)
are displayed graphically. The level reduction by the integrated limiter is displayed under GR (Gain
Reduction). If the red CLIP indicator lights up, this signals that the input stage is being operated above
the distortion limit. Reduce the output level of the feed device (e.g. mixing console) until the CLIP
indicator no longer lights up and the amplifier module plays back audio signals without distortion.
VOLUME
Adjust the level of the amplifier module by using the encoder directly from the main display, or select
VOLUME from the main menu, confirm and then set the desired value from -40 dB to +10 dB.
VOLUME
SPLAY ANGLES
SATELLITES
EQUALIZER
DELAY
Mute: Press the encoder for about 2 seconds to mute the speaker column and again for about 2
seconds to unmute it (at all menu levels).
VOLUME
SPLAY ANGLES
SATELLITES
EQUALIZER
DELAY
SPLAY ANGLES
Mounting on subwoofer:
To enable the automatic calculation of the optimal spreading angles of the satellites, the
rotation of the display must be set correctly.
ROTATION menu item, status: standing
The number of satellite speakers used is automatically detected by the module electronics if the status
ON is set in the menu item SATELLITES under AUTO DETECT . Alternatively, enter the corresponding
number of satellites manually under QUANTITY and deactivate the automatic detection(AUTO DETECT OFF).
To enter the relevant data of the audience area and the height at the measuring point, select SPLAY
ANGLES in the main menu, confirm, then select the corresponding submenu item and confirm again.
12
A
<
0.0
ms
A
4
Sat
LVL
VOL
A
0.0
ms
A
4
Sat
LVL
VOL
A
0.0
ms
A
4
Sat
LVL
VOL
A
0.0
ms
A
4
Sat
LVL
VOL
SATELLITES
EQUALIZER
DELAY
Publicité
