Publicité
Con guring the Switch Using the Console Port
Step 1: Connect a computer to the console port of the switch with the console cable.
Step 2: Start the terminal simulation software, such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: Baud rate to 115200, Data bits to 8,
Parity to None, and Stop bits to 1.
Quick Connect
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: After setting the parameters, click Connect to enter.
16
Serial
COM5 USB Serial Port
115200
8
None
1
Done
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
√
Save session
√
Open in a tab
Connect
Cancel
x
Publicité
