Installation Of The Sensor Base - Bosch PLS Manuel D'installation

Parking Lot Sensor | PLS

Installation of the sensor base

The bottom of the base has been processed with a plasma treatment for the adhesion of the glue
on the ground:
⇒ Take out the base of the sensor only just before putting down the glue there.
⇒ Do not touch the bottom side of the base with your hands or anything else.
⇒ Do not put the base on the ground before gluing, to avoid dust on the sensor base.
⇒ Ensure that all parts of the sensor device will be protected and will be kept clean till the installation
⇒ Check that the glue is compatible with the ground and the base of the sensor.
has been completed, so that these parts will be used only within the described intended use.
Insert the adhesive cartridge into the glue gun/adhesive press (Fig. 7 Inserting the adhesive cartridge; in the case of
DELO®-PUR 9692, the mixing ratio is 1:1, so you do not have to pay attention to the orientation of the cartridge). Then
attach the mixing tip on the cartridge by removing the cartridge cap (Fig. 8 Sealing cap adhesive cartridge) and
attaching the mixing tube (Fig. 9 Mixing tube on adhesive cartridge; here, bayonet fitting).
Figure 7 Inserting the cartridge
To avoid contamination and to get the maximum use out of the plasma cleaning process, open the sensor base
package just before applying the adhesive. In the case of DELO® PUR 9692, you apply about 40 ml of the adhesive in
the middle (see Fig. 10 Applying adhesive, and Fig. 11 Amount of adhesive); if you use a 50 ml cartridge, you can
empty it completely. Apply the adhesive in the form of a bubble in the center of the sensor base (no screws or even
surface).
INFORMATION:
The use of the mixing tube is important for mixing the two components of the adhesive and for the
resulting adhesive effect.
© Bosch Connected Devices and Solutions GmbH 2020. All rights reserved, also regarding and disposal, exploitation, reproduction, editing,
distribution, as well as in the event of application for industrial property rights.
Warning
Figure 8 Sealing cap
6 | 16
Figure 9 Mixing tube