Publicité
SAVE
•
Press T4. D1 displays the wording OP (ope-
rator point); D2 displays the operator point
number (saving slot).
•
Change through E2 and select the desired
operator point number from 1 to 30.
•
Save by holding T4 until D2 displays the wor-
ding SAV.
WIRE FEEDER
•
Power off the generator.
•
Power on the generator by holding T3 "SE-
TUP" until D1 displays the wording H2o.
•
Hold T4 until the generator restarts.
GENERATOR
•
Power off the generator and disconnect the
wire feeder.
•
Power on the generator by holding T5 "SE-
TUP" until D3 displays the wording H2o.
•
With E3 scroll thought the selectable parame-
METAL
GAS
Mild steel
CO2
Argon + CO2
Argon + CO2 + Oxygen
Aluminium
Argon
Argon + Helium
Stainless steel
98%Argon + 2% CO2 (C2)
80% Argon + 20% CO2
Argon + CO2 + Oxygen
Argon + Oxygen
Copper, Nickel
Argon
and Alloys
Argon + Helium
Table 3
Contact the technical service of your gas supplier to know the percentages of the different gases which are
the most suitable to your application.
SAVE AND RECALL (MIG ONLY)
FACTORY RESET
PROTECTION GASES GUIDE
NOTE
High Penetration
Argon controls spatters
Oxygen improves arc stability
Arc stability, good fusion and minimum spatter.
Higher heat input suitable for heavy sections. Minimum porosity.
Recommended.
Arc stability.
Minimum spatter.
Suitable for light gauges because of low flowability of the weld pool.
Higher heat input suitable for heavy sections.
RECALL
•
Press T4. D1 displays the wording OP (ope-
rator point); D2 displays the operator point
number (saving slot).
•
Change through E2 and select the desired
operator point number from 1 to 30.
•
Recall by pressing T4 to read REC on D2.
ters (H2o, diGitAL_MEtEr, unit, StArt_ModE,
droP _Cut, PLuS_ModE,VRD, Vcut e Param_
Reset) and select Param_Reset through T5.
•
Set Yes through E3.
•
Press T5 to confirm the reset.
•
Wait for the generator to restart.
EN-15
Publicité
