Publicité
A
Centralized Connection for the connection of
the welding torch on MIG/MAG welding.
Positive Current Socket (+)
B
•
for the connection of the earth cable on TIG
welding
•
for the connection of the welding cable or
earth cable according to the type of electrode
in MMA welding
C
Negative Current Socket (-)
•
for the connection of the earth cable on MIG/
MAG welding
•
for the connection of the torch on TIG welding
Mains switch for generator power ON and
D
OFF
E
Power Cable
F
Connection of gas feed hose
G
Water Cooling Connection for MIG Torch
•
Blue for the water feed hose connection
•
Red for the water return hose connection.
H
Drain Valve
D1
L10
L11
L12
E1
T2
Figure 8 - Wire feeder control panel
L1
Current LED [A]
lights up when the current parameter is displayed on
D1, this is expressed in Amps.
Note: by welding, L1 is always ON and D1 displays
the instantaneous supplied current.
L2
Speed LED
lights up when the wire speed parameter is displayed
on D1, this is expressed in m/min or in/min as per
the set unit of measurement.
CONTROL INTERFACE
L1 L2
L3
L4 L5
I
Male plug for Gas/No Gas voltage change
J
7-pole connector for the interconnecting ho-
sepack
K
Water Cooling Connection for Hosepack
•
Blue for the water feed hose connection
•
Red for the water return hose connection
L
Positive Current Socket (+) for the connection
of the interconnecting hosepack
M
Mains switch for water cooler power ON and
OFF
N
Protection Fuse
O
Compartment for Water Cooling Power and
Pressostat Cables Connection (inside the ge-
nerator by removing the closure plate on the
back side or the side panel depending on the
model)
P
Pressostat cable connection
Q
Water cooler input cable connection
L6
L7
L8 L9
L3
Thickness LED
lights up when the parameter of the thickness of
the material to be welded is displayed on D1. The
value can be expressed in mm or in tenths of an
inch depending on the set unit of measurement. This
LED can only be ON in synergy. Note: the indicated
thickness refers to the welding of a corner joint in
horizontal.
L4
Powered unit green LED
When lit, it means that the generator is properly
powered and ready for use; when blinking, it means
that the generator is temporarily unusable due to an
alarm or a change in the welding process.
EN-9
T1
D2
L13-L14
L15
L16
E2
T3
T4
Publicité
