Publicité
TROLLEY MOUNTING AND INSTALLATION
•
Follow the mounting instructions supplied with
the trolley to install the welding unit, compact
or with separate wire feeder and the cooling
unit.
WATER COOLER CONNECTION
Important: read also the Operating instruc-
tions supplied with the water cooler before
connecting it to the welding unit.
•
Remove the metal plate on the back side of
the generator to enter the compartment -
for the water cooler connection.
Figure 1 - Connector for water cooler on the generator
•
Refer to the Assembly Paragraph for the unit's
installation, for the connection of the hose-
pack and of the water cooler (if present).
•
Load the wire, connect the gas cylinder and
replace the wire liner if necessary, as descri-
bed in this paragraph.
•
Check line voltage and connect power cable.
For generators with water cooling unit:
•
Check the level of coolant in the cooling unit
and turn it on.
•
Power ON the welding unit. The display shows
the screen of the last welding process perfor-
med by the unit.
•
Check for the water cooling unit enabling on
the Basic Setup Menu before proceeding.
ASSEMBLY
O
PREPARATION FOR WELDING
•
Make the connection of the power cable and
of the pressostat through the rapid connec-
tors and close the compartment with the new
metal plate.
Important: The water cooler is activated
from the menu "Basic Setup". Refer to "Ba-
sic Setup" section.
HOSEPACK CONNECTION
•
Connect the plugs of the interconnecting ho-
sepack to the Positive Sockets -
power generator and -
-
•
Connect the military connectors of the inter-
connecting hosepack to the Sockets -
the wire feeder and on the power generator.
For generators with water cooling unit:
•
Connect the blue water feed hose of the in-
terconnecting hosepack to the connections
marked in blue -
feeder and water cooler.
•
Connect the red water feed hose of the in-
terconnecting hosepack to the connections
marked in red -
feeder and back side of the water cooler.
EARTH CABLE AND TORCH CABLE
CONNECTION
Ensure unit is powered off and unpluged
from the mains.
•
Connect the earth cable to the negative cur-
rent socket – C – of the power source.
•
Plug the torch hose into the socket – A –
on the front of the welder having care to not
damage the contacts and secure by hand
screwing in the threaded connection.
EN-5
- on the
B
- on the wire feeder.
L
- on the back side of wire
K
- on the front side of wire
K
- on
J
Publicité
